HONGKONG BITFOIC ELECTRONICS LIMITED

As the electronic part is packed in 20-VFQFN Exposed Pad, CSP, international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. 2:1 is the ratio of multiplexer to demultiplexer circuits. The operating temperature is extended to around -40°C~125°C TA. In total, there are 20 terminations. A high-quality output is provided by the electrical component's 1 channels. With a 5V voltage supply, the electrical component should be turned on and run. Electronic part bodies are injected with 20 pins. The analog switch ics are built using SPDT switching circuits. Try searching for the analog switch ic with ADG1634 if you are looking for variants. As far as internal resistance is concerned, it has 5Ohm. The functions of 20 pins can be found in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 16V. The digital multiplexer has a low cost Dual, Single supply. It is recommended that the electrical component receives a voltage of 3.3V. A digital multiplexer may suffer damage if voltage is applied above 600μA. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 8V. When using dual power supplies, you should attach at least 3.3V. Operating 4 inputs is required. It is possible to transfer data over a 103MHz-bandwidth. There is 10Ohm resistance between the Drain and Source on this part. 8 outputs are included in the analogue multiplexer.